Are you in Australia and looking to buy the amazing Sunlu Filadryer S2? The S2 features an extraordinary design with a heating module, 360° constant temperature, fast - drying capabilities, and a large screen for easy operation. The Phaser FPV ultimate filament drying guide: Use the Sunlu Filament Dryer to dry your filament and pair it with a Dryer Mount while printing. Monitor the humidity in the dryer with our Humidity Sensor and Humidity Mount. After printing, store the filament in airlock bags and remove air using the NanoVac Pump. Place a Humidity Sensor in our spool adapter to gauge the humidity on the spool for future prints. Storing in bags may reduce subsequent drying time. You can stack filaments in airlock bags, but watch out for sharp filament ends that could puncture the bags. If you have a clogged nozzle, try our nozzle cleaning filament! Product specifications include a size of 265(L) X 274(W) X 118(H) mm, a maximum capacity of φ210*85（H）mm, a net weight of 1190g (including power adapter). It works in an environment temperature of 20℃ - 35℃ and relative humidity ≤90%. The temperature setting range is 35℃ - 70℃. The power adapter has an input of AC 100V - 240V, 50/60Hz and an output of DC:24V±1.2, 2A. Standby power is 0.05W, maximum working current is 1.9A, and maximum working power is 48W. It has a 6.4 - inch LCD display and is suitable for filament diameters of 1.75mm/2.85mm. Browse all Filament Dryers and all Sunlu products.
Using the Sunlu Filadryer S2 is easy. First, put your filament into the dryer. Set the temperature according to your needs within the 35℃ - 70℃ range using the large and easy - to - operate screen. Let it dry. While printing, use the Dryer Mount to keep the filament ready. To monitor humidity, install the Humidity Sensor with the Humidity Mount. After printing, transfer the filament to airlock bags and use the NanoVac Pump to remove air. Place a Humidity Sensor in the spool adapter. When you stack filaments in airlock bags, be careful of sharp ends that could damage the bags. For maintenance, keep the dryer in an environment with a temperature of 20℃ - 35℃ and relative humidity ≤90%. Make sure the power adapter is properly connected. If the nozzle gets clogged, use the nozzle cleaning filament to solve the problem.
