The PTFE Tube Connector is a must - have component for your Bambu Lab printer. It's installed at the back of the printer and used to connect the PTFE tube between the buffer and the tool head. This connector is compatible with both the X1 Series and P1 Series. When installing, it has a clear direction. Connect the PTFE tube from the buffer output to the IN end and the one from the tool head to the OUT end. Incorrect installation may lead to material blockage. Also, when not using AMS, remove the feed tube connector from the OUT end and directly insert the consumable wire into the tool head's PTFE tube. Browse more Bambu Lab products, printer spare parts, and A1 Mini spare parts and accessories.
Here's how to use the PTFE Tube Connector. First, look at the clear direction of the connector. Connect the PTFE tube coming from the buffer output to the IN end and the tube from the tool head to the OUT end. Make sure to get the direction right, because if you connect it in reverse, it can cause the material to get blocked. When you're not using the AMS, take the feed tube connector off the OUT end. Then, just insert the consumable material wire directly into the PTFE tube of the tool head. As for maintenance, keep an eye on the connections to make sure they're tight. If you notice any signs of wear or blockage, check the connector and tubes and replace them if needed. Also, always handle the connector gently to avoid any damage.
