Are you in Australia looking to buy a Revo Hotend for your Creality Printer? Upgrade your Creality 3D printer to Revo and enjoy hassle - free nozzle changing. No special tools are needed to change nozzles cold, and you can avoid hot tightening. This hotend comes with pre - drilled M3 clearance holes that match Creality’s X carriage mounting pattern, so no extra mounts or adapters are required. Installation is a breeze! There's no need for firmware tweaks. The kit includes a special Revo HeaterCore with a 100K NTC thermistor, which responds the same as the stock Creality thermistor. Solderless, crimpless, butt splice connectors make wiring easy, so you don't have to undo your entire cable bundle. E3D's detailed upgrade guides will get you 3D printing quickly. With convenient M3 clearance holes, you can reuse existing M3 bolts and start running fast. A variety of Revo Nozzles enhance your printer's capabilities. You can change them by hand, no tools or hot tightening. The factory - sealed Revo Nozzles are more reliable, with less chance of leaks. The included Revo HeaterCore heats up your printer faster and more efficiently. You can start 3D printing right away without annoying firmware adjustments. Thanks to the built - in PTC behaviour of the heater, Revo CR adds an extra failsafe against thermal runaways. Revo CR is directly compatible with many Creality 3D printers like Ender 3, Ender 3 Pro, etc. Note that it can be used with other Creality printers using the NTC thermistor, but you may need to modify the mount or Z sensor and adjust the Z height when changing nozzles. Check your printer's voltage (12V or 24V) before purchasing and assembling. The max temp is 300°C. The kit contains 5 butt splice connectors, 1 Revo CR HeaterCore with an embedded 12V or 24V 40W heater cartridge and 100K NTC thermistor, and 1 Revo HeaterCore spring. M3 bolts are not provided.
Using your E3D Revo CR Hotend is a piece of cake. First, check if your Creality printer runs on 12V or 24V before you start the installation. The pre - drilled M3 clearance holes match Creality’s X carriage mounting pattern, so just reuse the existing M3 bolts to attach the hotend. You don't need to use extra mounts or adapters. Connect the HeaterCore using the solderless, crimpless, butt splice connectors provided. There's no need to undo your entire cable bundle. When it comes to changing nozzles, you can do it by hand, no tools or hot tightening required. This makes it super easy and quick. Now, for the important notes. If you're using the Revo CR with other Creality printers that use the NTC thermistor, you may have to make some changes to the mount or Z sensor. Also, remember to adjust the Z height when you change nozzles. And don't forget to check the max temperature of 300°C to avoid any overheating issues. As for maintenance, keep an eye on the Revo Nozzles. Since they're factory - sealed, they're quite reliable, but it's still a good idea to check for any signs of leaks. The HeaterCore should be inspected regularly to make sure it's working properly. If you run into any problems, refer to the detailed upgrade guides created by E3D.
