Product Information
Are you in Australia and searching for a Voron 254x254mm PEI Coated/Textured Spring Steel Sheet Build Plate? Look no further! This single-sided bed has a textured gold side with a red 'PHASER FPV' logo at the bottom. You can't print on the bare steel side. Made by Energetic, this build sheet takes your 3D printing to new heights. With a PEI coating, say goodbye to glue sticks and painters tape. Just clean the bed with isopropyl alcohol, start printing, and when done, flex the sheet to easily remove the print. Advantages? It never warps or rusts, helps new users get a perfect first layer, is flexible and sticks well to magnets, suits various filaments (especially PLA), offers free cleaning by simply flexing, has fast heater performance, and is a lifetime 3D printer bed. Features include a 0.2MM thick SmoothPEI with 3M468 tape, 100% real Ultem1000 (PEI) in amber color with a matte surface made in Europe, a flat and flexible spring steel sheet that sticks excellently to the bed magnet, and pre - applied 3M tape without bubbles. Recommended print temps are 60C for PLA and HTPLA, 70 - 80C for PETG and PCTG, and 100C for ABS.
Using this spring steel sheet is easy. First, clean the bed with isopropyl alcohol before starting a print. Set the print temperature according to the filament you're using: 60C for PLA and HTPLA, 70 - 80C for PETG and PCTG, and 100C for ABS. If you're printing PETG, PCTG, or TPU, apply hairspray or PVA gluestick to the PEI surface to prevent damage. When the print is finished, wait until the plate is close to room temperature (under 30C) before removing the part. You can easily remove the 3D print by taking out the spring steel plate, flexing it, and popping the print off. To maintain this sheet, keep it clean and dry. Avoid scratching the PEI surface, and it will serve you well for a long time as a great 3D printing accessory.
