Are you in Australia searching for a top - notch 24V fan for your Magnum Hotend? Look no further! This Slice Engineering Hotend Fan is a game - changer. It's designed to fit perfectly on the Mosquito Hotend or Mosquito Magnum Hotend from the same manufacturer. Even if you're using it with your existing 3D printing setup, it works great as a cooling component. With Japanese - developed bearings inside the module, it runs almost silently while keeping your printing job at the right temperature. Here are its amazing features: a high - quality 25 mm box fan with dual Japanese bearings, 3.64 CFM of air flow, a genuine Molex Micro - Fit 3.0 connector. It mounts directly to both Mosquito and Mosquito Magnum hotends with the included hardware. You can choose between 12V or 24V configurations, and there's also a 1 m extension cable available. Browse all Slice Engineering products here.
Using this Slice Engineering 24V fan is a breeze. First, check the voltage configuration (12V or 24V) that suits your 3D printer. Then, use the included hardware to mount it directly on your Mosquito or Mosquito Magnum hotend. Connect it using the Molex Micro - Fit 3.0 connector, and if needed, attach the 1 m extension cable. When using it, make sure the printer is turned off before making any connections. Keep the fan clean by gently blowing compressed air over it every few weeks to remove dust. If you notice any unusual noise, stop using it immediately and check for loose parts or debris. This will help ensure long - lasting performance and efficient cooling for your 3D printing projects.
