Are you in Australia and looking to purchase a replacement heat break for your Mosquito Magnum Hotend? Look no further! Slice Engineering's Bimetallic Heat Break™ is here to solve your problem. Its composite, bi - metallic construction makes it the thinnest and highest - performing heat break in production. Available for the standard Mosquito®, Mosquito® Magnum, and Mosquito® Liquid Hotends (note that the Mosquito® Liquid Hotend uses the Conduction Mosquito® Heat Break). It's also compatible with the new version of the Mosquito Magnum model hotend. If you're curious about the difference between the two versions, check out our blog post. Browse more Slice Engineering products, 3D printer spares, and 3D printing items.
Using this replacement heat break is easy. First, make sure your 3D printer is turned off and cooled down. Then, carefully remove the old heat break from your Mosquito Magnum Hotend. Take your new Slice Engineering heat break and install it in the same place. Ensure it's properly fitted. When using your 3D printer, keep an eye on the heat break's performance. If you notice any unusual behavior like poor filament flow, check the heat break. For maintenance, regularly clean the heat break to prevent any debris build - up. Also, don't over - tighten it during installation as this could damage it. Always refer to your 3D printer's manual for specific instructions related to your model.
