Aikon AK32 35A 2-6S 32bit DSHOT1200 Single ESC

Are you in Australia searching for a top - value single ESC? Look no further than the Aikon AK32 35A 2 - 6S 32 - bit DSHOT1200 ESC! This budget - friendly ESC is ideal for almost any quad. It's lightweight and incredibly user - friendly. Packed with all the best features, it offers a seamless flight experience. We even like to include these ESCs in customer orders! If you need an ESC more suited to 2 - 4S batteries, check out its sibling, the Aikon AK32 35A 2 - 4S Single ESC. **Features**: - New BLHeli_32 code base - Programmable PWM frequency up to 48KHz - Auto - timing for high efficiency and reliability - Voltage/Current limiting - Adjustable brake on stop force - Improved direction change in bidirectional mode - ESC telemetry - Configurable from FC using DShot commands **Specifications**: - 2 - 6s Lipo Input - 35A Constant Current - 45A Burst Current - 18*30mm size - Aikon_AK32_35A_Multi firmware - ST32F0 MCU - Bootloader - 12 grams with wire - 150mm signal wire length - 100mm battery wire length Browse more: - 2 - 4S AK32 Single ESC - All Aikon ESC's - All AIKON

Using the Aikon AK32 35A 2 - 6S 32 - bit DSHOT1200 Single ESC is a breeze. First, connect it properly to your quad. Make sure to match the battery input correctly according to the 2 - 6s Lipo range. You can configure it from the FC using DShot commands. This gives you control over various settings like the PWM frequency and brake force. When it comes to usage, keep in mind the current limits. The constant current is 35A and the burst current is 45A. Don't exceed these limits to avoid damaging the ESC. For maintenance, keep the ESC clean and dry. Check the wires regularly for any signs of wear or damage. If you notice any issues, replace the wires immediately. Also, make sure the ESC is well - ventilated during use to prevent overheating. If you need an ESC for 2 - 4S batteries, you can consider its 2 - 4S version.