GEPRC DarkStar20 WTFPV Cinewhoop Quadcopter

Are you in Australia and looking to buy a GEPRC DarkStar20 WTFPV Cinewhoop Quad? In the world of Cinematic FPV, GEPRC is always innovating. When regular-sized quadcopters can't meet the needs of shooting in tight spaces, the DarkStar20 is the answer. It's a small quadcopter weighing under 120 grams, perfect for both indoor shooting and outdoor flying. The DarkStar20 features a lightweight, fully-injected fuselage with a multi-dimensional triangular frame for strength. This gives it great frame rigidity and a sleek look. The flight system uses the TAKER F411-12A-E 1-2S AIO, and the SPEEDX2 1102 motor paired with HQProp T51MM x4 propellers offers plenty of power and efficiency. The O3 Air Unit version even has built-in 4K anti-shake video recording for amazing footage. After careful tuning by the GEPRC team, the Dark Star 20 offers a smooth flying experience. **Features** - New design with a lightweight, fully-injected fuselage and multi-directional triangular frame for strength. - Weighs just 85.5g without batteries. - Built-in O3 Air Unit can record up to 4K 120fps high-def video. - Suitable for indoor and outdoor flying, image creation, and great for beginners. - TAKER F411-12A-E 1-2S AIO flight system with integrated ELRS 2.4G receiver, saving space and cost-effective. - New SPEEDX2 1102 motor with HQProp DT51mm x4 propellers for good battery life. - Deep cooperation with HQProp to optimize the dynamic balance of the propellers and reduce jelly. - Compact and easy to carry, ideal for travel photography. - Frame-protected battery compartment for versatile battery use. - Adjustable camera protective hat to prevent damage when flipping. **Specifications** - Model: DarkStar20 WTFPV Cinewhoop Quadcopter (without camera) - Frame: GEP-DS20 - Wheelbase: 90mm - FC system: TAKER F411-12A-E 1-2S AIO - MCU: STM32F411CEU6 - Gyro: BMI270 - OSD: Betaflight OSD w/AT7456E chip - ESC: Bluejay 8Bit 12A - VTX: Without VTX - Camera: Without Camera - Antenna: 5.8G UFL sleeve dipole antenna - Motor: SPEEDX2 1102 10000KV - Propeller: HQProp DT51mm x4 - DarkStar20 WTFPV ELRS2.4G Weight: 50g ± 1g - Receiver: ELRS2.4G / TBS Nano RX - Recommended battery: LiPo 2S 500mah **Included** - 1 x DarkStar20 WTFPV Cinewhoop Quadcopter (without camera) - 2 x HQProp DT51mm*4 (2 pairs) - 1 x Plum screwdriver - 1 x Set of screws - 1 x Keychain **Browse more** - Browse all GEPRC - Browse all HD BNF - Browse all BNF

Using the GEPRC DarkStar20 WTFPV Cinewhoop Quadcopter is a breeze. First, make sure you have the recommended LiPo 2S 500mah battery. Insert the battery into the frame - protected battery compartment. Then, turn on the quadcopter and your receiver. Once it's all powered up, you're ready to take off! When flying, remember that this quadcopter is great for both indoor and outdoor use. Indoors, it can easily maneuver in small spaces, while outdoors, it can capture beautiful aerial shots. If you're a beginner, start with short flights in an open area to get used to the controls. For maintenance, regularly check the propellers for any signs of damage. If they're worn out or broken, replace them with the spare HQProp DT51mm x4 propellers that come with the quadcopter. Also, keep the camera protective hat adjusted properly to avoid any damage when the quadcopter flips over. After each flight, make sure to turn off the quadcopter and remove the battery to preserve its lifespan. And don't forget to clean the quadcopter gently with a soft cloth to keep it in top condition.