Are you in Australia looking to buy an iFlight Blitz Whoop AIO Board? This is the latest iFlight BLITZ series all-in-one flight controller for your ultimate build. It combines an F411 flight controller, 5A ESC, 50mW VTX, and a built - in ELRS receiver. It's lightweight, small - sized, and easy to install. Key features include support for BLHeliSuite programming, a built - in ELRS 2.4G CC2500 receiver, 5A continuous current, and it weighs only 4.8g. The power supply is 1S, and it uses a BMI270 gyro. Specifications cover various aspects from the flight controller to the ESC and VTX. It comes with 1 x BLITZ F411 1S 5A Whoop AIO Board with Built - in 2.4G CC2500 Receiver, 4 x M2 Rubber Balls, and 1x Whip antenna. Note that it supports F.PORT protocol RX input but no telemetry.
Using this iFlight BLITZ F4 Whoop AIO Board is a breeze. First, make sure you connect all the components correctly. Attach the power cable, VTX, and VTX antenna as shown in the manual. For programming, use the BLHeliSuite software as it's supported by the board. When powering it, use a 1S power supply only. Regarding the ESC, you can choose different signal supports like Dshot, Oneshot, or Multishot according to your needs. As for the VTX, it has a Smart audio protocol and can output power at PIT/25/50mW. Just set the channels you want within the 48CH range. Important note: it supports F.PORT protocol RX input but doesn't support telemetry. For maintenance, keep it clean and dry. Avoid exposing it to extreme temperatures or moisture. If you notice any issues with the current sensor or other components, check the connections first. Store it in a safe place when not in use to prevent physical damage.
