BigTreeTech BIQU Panda Hotend

Are you in Australia and looking to buy a BIQU Panda Hotend? This is a must - have for Bambu P1P/P1S owners! We're excited to present BIQU’s new collaborations with E3DOnline and Bondtech. The Panda series hotend is plug - and - print. It's fully compatible with the original Bambu P1P/P1S hotend and supports the two most popular nozzle standards, V6 and Revo, giving you endless possibilities. Installation is super easy, no soldering or retrofitting needed. You can start printing in minutes. The standard Panda hotend comes with a brass v6 nozzle, and you can freely install your favorite nozzles. With a high - power 60w ceramic heater, it offers high flow rates for high - speed printing and precise temperature control.

Using the BIQU Panda Hotend is a piece of cake. First, make sure your printer is the Bambu P1P or P1S as it's specifically designed for these models. Install the hotend by simply plugging it in; no soldering or complex retrofitting required. Once it's installed, you can start printing within minutes. When it comes to nozzles, the standard one is a brass v6, but you're free to swap it out with your favorite nozzle on the market. For high - speed printing, the 60w ceramic heater does an excellent job, but keep an eye on the temperature to ensure precise results. As for maintenance, regularly check the nozzles for any blockages. If you notice the print quality dropping, it might be time to clean or replace the nozzle. Also, make sure to keep the hotend in a clean environment to avoid any debris getting in and causing problems.