Product Information
Are you in Australia and looking for a high - quality 3D printer build sheet? Look no further than the Energetic 254x254mm Double - Sided Textured Black PEI PRO Spring Steel Sheet, perfect for Voron 250mm printers. This bed is double - sided and has no magnet. The textured side is black in the PEI PRO HF Version and features the PHASER FPV logo in red at the bottom. Made by Energetic, it offers many benefits. With a PEI - coated build sheet, you'll take your 3D printing to a new level. No more worries about glue sticks, painters tape, or prints not sticking. Just clean the bed with isopropyl alcohol, start printing, and when done, flex the build sheet and the print pops off. Advantages include no warping or rusting, easy first - layer printing for new users, flexibility, removability, strong magnet adhesion, compatibility with various filaments (especially PLA), easy cleaning by flexing, fast heater performance, and it's a lifetime 3D printer bed. The smooth PEI has a 0.2MM thickness with 3M468 tape. It's made of 100% real Ultem1000 (PEI) in amber color with a matte surface from Europe. The spring steel sheet is flat, flexible, and sticks well to the bed magnet. The PEI has pre - applied 3M tape without bubbles. Recommended print temps are 60C for PLA and HTPLA, 70 - 80C for PETG and PCTG, and 100C for ABS.
Using this Energetic spring steel sheet is easy. First, clean the bed with isopropyl alcohol before starting a print. Set the print temperature according to the filament you're using: 60C for PLA and HTPLA, 70 - 80C for PETG and PCTG, and 100C for ABS. When printing PETG, PCTG, or TPU, to avoid bonding the filament to the PEI surface and damaging it, apply hairspray or PVA gluestick before printing. After the print is finished, wait until the plate is close to room temperature (under 30C) before removing the part. To remove the print, simply take out the spring steel plate, flex it a bit, and the print will pop off. Maintenance is simple. Keep the sheet clean with isopropyl alcohol. If you notice any issues with adhesion over time, you can check the 3M tape on the PEI and re - apply if necessary.
