The E3D Revo ObXidian High Flow Nozzle is incredibly hard, with wear resistance much higher than other E3D nozzles. It's several times harder than Nozzle X and generic hardened steel nozzles. This is thanks to a tool steel insert paired with our new E3DLC™ coating. This special coating gives the nozzle non - stick properties, reducing plastic build - up. The Revo ObXidian™ High Flow boosts your setup's volumetric flow rate, allowing faster printing of abrasive materials. It has the same form factor as standard Revo HotEnds, so no need to adjust your existing mounts and fan ducts. The unique internal geometry increases the surface area for better heat transfer to the filament. It unlocks higher flow for 0.4mm, 0.60mm, and 0.80mm nozzles and adds 1.00mm, 1.20mm, and 1.40mm sizes. Nozzle swapping is a breeze, so you can freely experiment with different nozzles. In case of clogs, just unscrew and replace. Each Revo Nozzle is a pre - assembled unit, eliminating hot tightening and incorrect assembly. A colour - coded silicone sock and engraved size numbers make it easy to identify nozzle sizes. Note: Revo™ Nozzles aren't compatible with V6 - style HeaterBlocks, and you may need to adjust your Z offset when changing nozzles.
Using the E3D Revo ObXidian High Flow Nozzle is straightforward. First, make sure it's compatible with your 3D printer as it's not for V6 - style HeaterBlocks. When you install or change the nozzle, you might need to adjust the Z offset. Swapping nozzles is easy: just unscrew the old one and replace it with a new one. This reduces your printer's downtime. Thanks to the colour - coded silicone sock and engraved size numbers, it's simple to pick the right nozzle for your project. To keep it in good condition, regularly check for plastic build - up. The special coating helps reduce this, but if you notice any, clean it gently. Also, since it's pre - assembled, there's no need to worry about hot tightening or incorrect assembly. Enjoy reliable 3D printing with this high - performance nozzle!
