Product Information
Are you in Australia and looking to buy an Energetic 508x508mm double-sided textured black PEI PRO spring steel sheet that suits Ratrig? This amazing bed is double-sided, with the textured side in black PEI PRO HF Version and a Red PHASER FPV logo at the bottom. Made by Energetic, it takes your 3D printing to a new level. With a PEI-coated build sheet, you'll never need glue sticks or painters tape again. Just clean the bed with isopropyl alcohol, press print, and when done, flex the sheet and the print pops right off. Advantages include no warping or rusting, easy first-layer printing even for new users, flexibility, strong magnet adhesion, compatibility with various filaments (especially PLA), free cleaning, fast heater performance, and it's a lifetime 3D printer bed. Features a flat spring steel sheet and a strong magnetic base (1.5MM, 300LSE tape, magnetism - 600GS, high temp resist up to 130C for long time). It's made of 100% real Ultem1000 (PEI) in amber color with a matte surface, made in Europe. PEI has pre - applied 3m tape, bubble - free. Recommended print temps are 60C for PLA and HTPLA, 70 - 80C for PETG and PCTG, and 100C for ABS.
Using this Energetic spring steel sheet is easy. First, clean the bed with isopropyl alcohol before starting a print. Then, set the appropriate print temperature according to the filament you're using (e.g., 60C for PLA). When it comes to PETG, PCTG, or TPU, apply hairspray or PVA gluestick before printing to prevent damage to the PEI surface. After the print is finished, wait until the plate is close to room temperature (under 30C) before removing the part. To remove the print, simply take out the spring steel plate, flex it a bit, and the print will pop off. For maintenance, keep it clean and store it in a dry place. That way, you can enjoy high - quality 3D printing for a long time.
