Slice Engineering 50W 12V Heater Cartridge

Are you in Australia and seeking a Slice Engineering 12V 50W Heater Cartridge? Visit our Phaser FPV store on the Central Coast - Gosford, NSW, or order online today. Explore the full Slice Engineering product range and all our Heater Cartridges. This heater cartridge is 22 mm long and fits a 6 mm H7 tolerance hole. It comes with 1 - meter - long leads and is available in 12V or 24V options, boasting 50W of power. Just like upgrading your car's engine, this 50W Heater Cartridge transforms your 3D printer, enabling it to handle engineering - grade plastics like Nylon, Ultem, PEEK, perfect for molds, medical devices, end - use parts, or automotive components. With a simple plug - and - play modification, it takes your printer's power to a new level. The 1 - meter cables make it easy to connect to even the largest printer's control board. Why buy from Phaser FPV? We're the official Slice Engineering distributor in Australia, offer express shipping on orders over $250, and we use these products in our Prusa printer farm!

Using this Slice Engineering heater cartridge is a breeze. First, make sure your 3D printer is turned off. Then, find the spot where the old cartridge was installed. It's designed to fit into a 6 mm H7 tolerance hole, so it should slide in easily. Connect the 1 - meter leads to the control board of your printer. That's it - simple plug and play! When it comes to using your 3D printer with this cartridge, you can now work with engineering - grade plastics like Nylon, Ultem, and PEEK. Just load the right type of plastic filament and start your printing job. As for maintenance, keep the cartridge clean. Check the leads regularly to make sure they're not loose or damaged. If you notice any issues, don't hesitate to contact us. And remember, always turn off your printer before making any changes to the cartridge. This will keep you safe and protect your printer.