Are you in Australia and looking to buy an ImpulseRC Apex EVO DC 5' FPV Frame Kit? The APEXDC EVO 5' Frame enhances the classic 'Dead Cat' geometry for freestyle, videography, and mid - range exploration. Note: Kits are being packed, and shipping starts on April 27th. The ApexDC EVO features unique arm geometry. It's a modified 'Dead Cat' frame that keeps front and rear motors aligned, maintaining the popular compressed - x motor layout. This ensures balance and doesn't compromise flight handling, unlike the classic design. By only modifying upper and lower main plates, it's fully compatible with regular Apex arms. There are no props in the shot of DJI HD flight cameras, and for slow cinematic flying, you can set GoPro angles lower. The kit includes a redesigned aluminium camera mount and 3D printed insulation inserts. It keeps the camera steady, reduces vibrations, and electrically isolates it from the frame. With different cameras on the market, the EVO camera mount has 4 mounting positions, 2mm apart, allowing you to adjust the camera's position. For quick GoPro angle changes, the Mr Steele version comes with a 3D printed mount and a custom - designed aluminium bolt. It saves weight and can be adjusted with common tools in your flight bag. Modern HD video systems can ground the frame, but this kit includes a mylar insulator and non - conductive 'cone rivets'. It isolates the HD video system and mounting hardware with only 0.5g extra weight. Every kit has a 3D printed antenna mount, and the Mr Steele version also has a standoff mount for the Tracer Immortal - T antenna. The ApexDC kit contains carbon fiber parts, hardware, camera mount, isolation parts, antenna mount, skids, bumper, wire covers, battery pads, files, and a battery strap. The Mr Steele kit adds a GoPro mount, Tracer Immortal - T mount, lightweight hardware kit, brown skids, vibration mounts, XT - 60 pigtail, foam strip, and an additional battery strap.
Using the ImpulseRC Apex EVO DC 5 FPV Frame Kit is a breeze. First, assemble the carbon fiber frame parts with the provided hardware and standoffs. When installing the camera, use the aluminium and TPU camera mount. Adjust its position according to your camera model by rotating the TPU inserts and choosing the right bolt as the pivot point. For the GoPro, use the custom - designed bolt in the 3D printed mount to quickly change angles. Install the HD video system and use the included mylar insulator and 'cone rivets' to isolate it from the frame. Attach the antenna to the 3D printed mount, and if you have the Mr Steele version, add the Tracer Immortal - T antenna to its standoff mount. Remember, the kits are still being packed, and shipping is expected to start on April 27th. When handling the frame, be gentle to avoid damaging the carbon fiber parts. Keep the parts clean and dry to prevent corrosion of the hardware. If you're using the GoPro mount, make sure the custom bolt is tightened properly. For long - term storage, keep the frame in a cool, dry place and protect it from dust and moisture. Regularly check the battery pads, straps, and vibration mounts for wear and tear, and replace them if necessary.
