JST SH 1.0 DIY Silicone Cable Set - NO MOLEX 1.25

Are you in Australia and on the hunt for a JST SH 1.0 DIY silicone cable set? This set doesn't include the Molex harness - it's all about the JST SH 1.0! With this wiring harness kit, you won't have to guess if the cables fit your 4 in 1 ESCs, flight controllers, VTXs, and cameras. No more hoping you have the right pinout at hand - make your own custom cables! The cables are made of silicone, which is flexible and won't shrink when you use your soldering iron. Both ends of the wires are pre - crimped. And it comes with male pieces only, as they're the most commonly used in wiring harnesses. Here's what's included: double - crimped silicone wires in different lengths (12 each of 50mm, 100mm, and 150mm) and JST - SH connectors (1.0mm pin spacing) with various pin counts (4x 3 - pin, 10x 4 - pin, etc.). Browse our full range of wires, harnesses, and accessories.

Using this JST SH 1.0 DIY silicone cable set is a breeze. First, figure out which cable lengths and pin counts you need for your 4 in 1 ESCs, flight controllers, VTXs, or cameras. Then, simply connect the pre - crimped male ends to your devices. When soldering, don't worry about the silicone wires shrinking as they're heat - resistant. As for maintenance, keep the cables in a dry place and avoid bending them too sharply. If you notice any fraying, it's best to replace the cable. Always double - check the pinout before making connections to ensure everything works properly.