Walksnail WS-M181 GPS Module with Built in Mag COPJ-18GPS

Are you in Australia looking to buy a high - performance GPS module? The Walksnail WS - M181 GPS Module is your ideal choice. It's small, light, and offers fast positioning and a stable connection. Perfect for FPV, RC airplanes, and quadcopters, it significantly enhances your flight experience. Featuring the u - blox M10 platform UBX - M10050 GNSS chipset and a built - in QMC5883 compass, it provides stronger performance and more accurate positioning. The ultra - thin ceramic antenna, with a special spray - painting process, resists oxidation and scratching, ensuring consistent positioning. With a built - in battery, it can achieve a hot start and rapid positioning. It has six positioning modes, including the default GPS + GLONASS + BDS multi - mode, and can search up to 32 satellites. Note: Since it uses a 10th - generation GPS chip, your flight controller should flash firmware Betaflight 4.3.0 or higher, and firmware below 4.29 uses the NMEA protocol.

Using the Walksnail WS - M181 GPS Module is easy. First, make sure your flight controller has the right firmware. If it's a new 10th - generation chip, flash Betaflight 4.3.0 or higher. If it's below 4.29, use the NMEA protocol. Then, connect the module to your device, and it will start working quickly thanks to the built - in battery for a hot start. When flying, the module will provide accurate positioning in different modes. For maintenance, keep it in a dry place within the operating temperature range of - 40℃ to + 85℃. Avoid scratching the antenna, as it has a special process to prevent oxidation. If you store it, make sure the temperature is between - 40℃ and + 105℃.