3DXTech R-PETG Ecomax Filament 1.75mm

Are you in Australia and eager to buy high - quality 3D printing filament? Look no further than 3DXTech R - PETG Ecomax 1.75mm. Ecomax® rPETG is a tough and flexible material. Its base resin is FDA - approved, offering better chemical resistance than PLA or ABS. You can clean it with isopropyl alcohol if needed. The benefits of rPETG are amazing. It has superior chemical resistance compared to ABS, very low odor during printing, an amorphous structure with low shrinkage, low moisture absorption (3x lower than ABS), a wide processing temperature range from 230 - 260°C, and better ductility than ABS. The filament comes in 1.75mm and 2.85mm diameters with a tolerance of +/- 0.05mm. For printing, set the extruder at 230 - 260°C, the bed temperature at 60 - 90°C. A heated chamber is not necessary. Dry it at 65°C for 4 hours before use. Browse all 3DXTech products for more options.

Using 3DXTech R - PETG Ecomax 1.75mm filament is easy. First, make sure to dry the filament at 65°C for 4 hours to remove any moisture. Then, set your extruder temperature between 230 - 260°C and the bed temperature between 60 - 90°C. You don't need a heated chamber. When printing, you'll notice it has very low odor. After printing, if your print needs cleaning, you can use isopropyl alcohol. Keep the filament in a dry place to maintain its low moisture absorption property. If you store it properly, it'll keep its great printing performance for a long time. Enjoy creating amazing 3D prints with this high - quality filament!