Are you searching for Bambu Labs PC Filament 1kg in Australia? This filament comes with RFID for intelligent printing. All printing parameters are embedded in the RFID, and can be read via our AMS (Automatic Material System). Just load and print, no more boring setting steps! Recommended printing settings include pre - printing drying at 80 °C for 8 hours, keeping container humidity below 20% RH (sealed, with desiccant), nozzle temperature between 260 - 280 °C, bed temperature (with PVP glue) from 90 - 110 °C, and printing speed below 300 mm/s. It has specific physical properties like a density of 1.20 g/cm³, Vicar softening temperature of 119 °C, etc. And mechanical properties such as tensile strength of 62 ± 2 MPa. Each pack includes 1x filament & desiccant, instructions & spool sticker, and 1x filament label. After printing, follow the steps to assemble the printed spool. Click here to learn more about swapping the new filament with Bambu Reusable Spool on Wiki. Also, you can browse a wide range of related products and filaments.
Using this Bambu Lab PC Filament is easy. First, check the recommended printing settings. Dry the filament at 80 °C for 8 hours before use. Keep the container's humidity below 20% RH by sealing it with a desiccant. Set the nozzle temperature between 260 - 280 °C and the bed temperature (with PVP glue) from 90 - 110 °C. Print at a speed below 300 mm/s. After printing, you'll get a wide piece, a narrow piece, and two spacing shims. Align the locator on the wide piece with the notch on the inner ring of the filament roll and insert it. Then insert the narrow piece, align the grooves, and push it firmly into the wide piece. Rotate the narrow piece clockwise until it locks. Make sure to install the spacing shim under the triangle inside the spool and tear out the plastic strips. When it comes to maintenance, always store the filament in a dry place to keep its quality. If you want to swap the filament, check out the details on the Wiki.
