Searching for Bambu Lab Support Filament for PA/PET in Australia? This filament comes with RFID for intelligent printing. All printing parameters are stored in RFID, readable via our AMS (Automatic Material System). Just load and print, no more boring setting steps! Here are the recommended settings: dry at 80 °C for 8 - 12 hours before printing. Keep the container's humidity below 20% RH (sealed with desiccant). Set the nozzle temperature between 260 - 290 °C, the bed temperature (with PVP glue) between 80 - 100 °C, and print at a speed less than 100 mm/s. Its physical properties include a density of 1.17 g/cm³ and a melting temperature of 255 °C. Compare it with support for PLA: it's green, needs a higher nozzle and bed temperature, and a slower print speed. It's recommended for PA - CF, PA - GF, PET - CF. Each package includes 1x 0.5kg filament with desiccant and 1x filament label. Also, explore more filaments and 3D printing supplies on our site.
How to use this Bambu Lab support filament: First, make sure to dry the filament at 80 °C for 8 - 12 hours before you start printing. Keep the container sealed with a desiccant to maintain humidity below 20% RH. Load the filament into your printer. The RFID will automatically read the printing parameters through the AMS system, so you don't have to set them manually. Set the nozzle temperature between 260 - 290 °C and the bed temperature (with PVP glue) between 80 - 100 °C. Print at a speed less than 100 mm/s. Remember, this support filament can't be used to print an item alone. It's only for the supporting part of an item. For multi - material printing, using AMS is recommended. Always use it with compatible temperatures and filament types. If you don't follow these rules, you may encounter clogs or other issues. To maintain the filament, keep it in a dry place and make sure the container is sealed. When not in use, put it back in the sealed container with the desiccant to prevent moisture absorption.
