Bondtech Prusa Mini Extruder Upgrade To IFS™

Upgrade your Prusa Mini or Mini+ with this amazing set. It's compatible with the Prusa filament sensor. The Bondtech Internal Filament Sensor (IFS) Extruder for Prusa Mini can embed the new Prusa filament sensor on its front housing. You can use the extruder with or without the filament sensor. The front housing has a plug that acts as a placeholder for the filament sensor steel sphere, allowing use without the sensor. If you want to use the IFS Extruder with the Prusa Filament Sensor, just remove the plug and follow the guide to install the accessories. This kit includes a 10076 - 3 Front Housing (PA12), a 10076 - 4 IFS Magnet Holder (PA12), a 10076 - 5 IFS Lever (PA12), and a 15112 IFS Extruder Plug (HT - PLA). Note that the Prusa Filament Sensor, Filament Sensor Magnets, and Filament Sensor Steel Sphere are not included. The original Bondtech extruder design was proposed by Olof Ogland, and the new IFS version was developed by Vecko Kojchevski based on the well - tested BMG. The EAN Code is 7350011413959, and the net weight is 102.3g.

Using this Bondtech IFS Extruder upgrade kit is easy. First, check if you want to use the filament sensor. If not, you can use the extruder right away with the plug in place. If you want to use the filament sensor, remove the plug from the front housing and follow the guide to install the sensor and other accessories. When installing, make sure all parts fit correctly and are tightened properly. For maintenance, keep the extruder clean. You can use a soft brush to remove any dust or debris. Check the parts regularly for wear and tear. If you notice any issues, replace the parts as needed. Remember, the Prusa Filament Sensor, Filament Sensor Magnets, and Filament Sensor Steel Sphere are not included in the kit, so you'll need to get them separately if you want to use the sensor.