Slice Engineering Copperhead Heat Sink

Are you in Australia looking to buy the Slice Engineering Copperhead™ Heat Sink? The Copperhead Standard Heat Breaks are now 3 mm longer to fit Raise3D machines. The new one is called the Copperhead Heat Break - Standard - G2, and the matching heat sinks are the Copperhead Heat Sink - Groove Mount - G2 and Copperhead Heat Sink - Screw Mount - G2. Copperhead is an economical, open - source hot - end from Slice Engineering. It started as a Kickstarter project to offer a new hot - end for almost every printer, preventing heat creeps. The Copperhead™ is a low - cost, open - source option that can handle heat creep. Replace your factory hotend with it to boost your 3D printer's performance, reduce jams, and enjoy smooth prints every time. Browse all Copperhead Hotends and Slice Engineering products.

Using the Slice Engineering Copperhead Heat Sink is easy. First, make sure your 3D printer is turned off and cooled down. Then, remove the old heat sink and install the Copperhead Heat Sink according to the type (groove mount or screw mount). It's important to note that this heat sink is designed for specific machines, like Raise3D ones, so double - check compatibility. When using it, avoid applying excessive force during installation to prevent damage. For maintenance, keep it clean. You can gently wipe it with a soft cloth every once in a while. If you notice any signs of wear or damage, replace it promptly to ensure your 3D printer keeps performing well.