Airbot Fenix SuperF4 Flight Controller Beta Version

Are you in Australia and looking to buy a top - notch flight controller? The Airbot Fenix SuperF4 Flight Controller (Beta Version) is your ideal choice. This F4 FC runs almost as fast as the F722 (1022 points compared to 1082 points). It comes with 8 UARTs and a 4MB Flash area, while the F722 only has 6 UARTs and 512KB. This amazing setup allows the SuperF4 to run a full 8K PID Loop and still maintain 50% idle CPU time. Specifications include: MCU is AT32F435 with 4MB Flash, gyro is ICM42688, it has a barometer, a 128Mbit (16MB) Blackbox, 2x BEC (5V2A, 10V2A), OSD support, and digital system support. Also, you can browse more related products like all ESC, all FPV, and all 4in1 ESC.

Using the Airbot Fenix SuperF4 Flight Controller is quite straightforward. First, make sure to connect it properly according to the wiring diagram. Power it on and start setting up the parameters in your flight software. It's important to note that since this is a beta version, there might be some minor glitches, so keep an eye on its performance during the initial flights. For maintenance, keep it in a dry and clean place. Avoid exposing it to extreme temperatures or strong magnetic fields. If you notice any signs of damage or abnormal behavior, check the connections and consult the user manual or customer support.