These awesome transfer stickers are a must - have! First, clean the application area thoroughly with rubbing alcohol or soap and water. Avoid using Windex as it leaves a residue that can stop the sticker from sticking well. To prepare the sticker, firmly rub a squeegee or credit card across the clear transfer tape. This gets rid of air bubbles and makes the sticker stick to the tape. Then, peel off the white paper backing. If the sticker clings to the backing, put it back and repeat the preparation step. Slowly lower the sticker onto the surface and firmly rub it in place with a squeegee or credit card. Wait a couple of minutes before moving on. Next, slowly peel the clear transfer tape off at an angle, being careful not to pull the sticker off. If it does, repeat the rubbing step. You can use a pin to poke any air bubbles in the center and push out the air. The best temperature for applying these graphics is 21 degrees. For the best results, don't apply stickers in extremely hot or cold conditions. Check out the steps in the pictures below.
Hey there! Using these Phaser FPV transfer stickers is a breeze. First, make sure to clean the area where you want to stick them. You can use rubbing alcohol or soap and water. Just don't use Windex because it'll leave a yucky residue that stops the sticker from sticking. Now, get your squeegee or a credit card and rub it firmly across the clear transfer tape. This will get rid of any air bubbles and make the sticker stick to the tape. After that, peel off the white paper backing. If the sticker sticks to the backing, don't worry! Just put the paper back and rub the tape again. Then, slowly lower the sticker onto the surface and rub it in place with your squeegee or card. Wait a couple of minutes. Next, gently peel the clear transfer tape off at an angle. Be super careful not to pull the sticker off. If it does come off, just repeat the rubbing part. If you see any air bubbles in the middle of the sticker, use a pin to poke them and push out the air. Also, remember the best temperature to apply these stickers is 21 degrees. Don't try to stick them on when it's really hot or cold outside. That's it! Enjoy your cool new stickers.
