Are you in Australia and looking to buy the ultimate desktop post - processing solution? The Polysher™ is here! It's designed to effortlessly remove layer lines from PolySmooth™ and PolyCast™ prints. Using Polymaker’s innovative Layer - Free™ technology, it creates a fine isopropyl alcohol mist to evenly smooth your models. Key features include: achieving professional - grade smooth and glossy surfaces for 3D printed parts; being incredibly intuitive and easy to use - just turn the control dial to set your 20 - 40 minute polishing time and relax. Safety is a top priority as it's air - tight sealed, and it uses a safer cold liquid - phase polishing process instead of dangerous heated vapour - phase smoothing. Specifications: Compatible with PolySmooth™ and PolyCast™, uses alcohol (>70%) like IPA or Ethanol, has a 150mm x 180mm polishing area, operates at 15 – 32 °C, and stores at 0 – 38 °C. It runs on AC 100 – 240V, 50/60Hz, 0.4A. Browse more Polymaker products and filaments like ASA, ABS, Nylon, and more.
Using the Polysher™ is a breeze. First, make sure you have a 3D print made of PolySmooth™ or PolyCast™. Fill the unit with alcohol (at least 70% like IPA or Ethanol). Place your model inside the 150mm x 180mm polishing area. Then, simply turn the control dial to select your desired polishing time, which usually takes between 20 - 40 minutes, but it can vary based on part size, alcohol concentration, and the ambient temperature. During operation, keep the room temperature between 15 – 32 °C. When storing, make sure the temperature is between 0 – 38 °C. Always remember that the unit is air - tight sealed for safety, but don't try to open it during the polishing process. After each use, empty the remaining alcohol and clean the interior gently with a soft cloth. If you notice any issues with the power supply, which is AC 100 – 240V, 50/60Hz, 0.4A input and 5V – 2000 mA output, contact the manufacturer ShenZhen Rongweixin Technology Co., Ltd.
