eSun PETG 3D Print Filament 1.75mm 2.5kg

Are you in Australia and seeking to purchase eSun PETG Filament in a 2.5kg bulk pack? The eSun PETG 3D Filament brings together the best of ABS and PLA filaments. It's an easy - to - print material boasting high toughness, heat resistance, good layer adhesion, and a bit of flexibility. Key Benefits: It combines ABS's strength, temperature resistance, and durability with PLA's ease of printing. It has high mechanical strength, excellent flexibility, great layer adhesion, less warping and shrinkage, and is 100% recyclable. Printing Parameters: Print at 240 - 255℃, set the bed temperature at 80 - 90℃, and keep the printing and moving speeds between 30 - 60mm/s. 2.5kg Spool Dimensions: The spool has a diameter of 270mm, a width of 104mm, and a mounting hole diameter of 52.5mm. Browse more eSun PETG, all PETG, and all eSun products.

Using this eSun PETG 3D print filament is easy. First, set your printer's temperature between 240 and 255℃ and the bed temperature between 80 and 90℃. Then, keep the printing and moving speeds steady between 30 and 60mm/s. When you're done printing, make sure to store the filament in a dry place to avoid moisture absorption. Also, always check the spool dimensions before installing it on your printer. If you notice any issues during printing, like poor layer adhesion, try adjusting the temperature a bit. And remember, this filament is 100% recyclable, so do your part for the environment when it's time to replace it.